Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy

ZHANG Zhao; GUO Baoqiao; RAN Chun; CHEN Wen; CHEN Pengwan

doi:10.11858/gywlxb.20210762

Volume 35 Issue 6

Nov 2021

Turn off MathJax

Article Contents

Chinese Journal of High Pressure Physics > 2021 > 35(6): 064104.

ZHANG Zhao, GUO Baoqiao, RAN Chun, CHEN Wen, CHEN Pengwan. Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy[J]. Chinese Journal of High Pressure Physics, 2021, 35(6): 064104. doi: 10.11858/gywlxb.20210762

Citation:

ZHANG Zhao, GUO Baoqiao, RAN Chun, CHEN Wen, CHEN Pengwan. Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy[J]. Chinese Journal of High Pressure Physics, 2021, 35(6): 064104. doi: 10.11858/gywlxb.20210762

Citation:

PDF( 13597 KB)

Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy

doi: 10.11858/gywlxb.20210762

ZHANG Zhao^1
,,
GUO Baoqiao^{1,*
,
,},
RAN Chun^{1, 2},
CHEN Wen¹,
CHEN Pengwan¹

1.
State Key Laboratory of Explosion Science and Technology, Beijing Institute of Technology, Beijing 100081, China
2.
China Ordnance Society, Beijing 100089, China

Received Date: 30 Mar 2021
Rev Recd Date: 09 Apr 2021

Abstract

Abstract

The effect of solution temperature on the dynamic mechanical properties and microstructure of near-β-phase TB6 titanium alloy was studied. Dynamic compression tests were carried out through the split Hopkinson pressure bar (SHPB) system, with untreated and treated TB6 titanium alloy specimens. The results indicate that both the untreated and treated TB6 titanium alloys perform the strengthening effect of strain rate, and their compression mode is exhibited as the typical shear failure. The solution temperature that converts the strain hardening of TB6 into strain softening is ranging from 700 ℃ to 750 ℃. The microscopic performance characterized by optical microscope (OM), X-ray diffraction (XRD) and scanning electron microscopy (SEM) methods show that the primary α-phase in TB6 is partially dissolved and the strength decreases after a solution treatment at 700 ℃. When the solution treatment is equal to or greater than 750 ℃, the primary α-phase is completely transformed into β-phase. The β grain becomes bigger and the strength increases, but the plasticity decreases evidently.
- TB6 titanium alloy,
- solution treatment,
- dynamic mechanical properties,
- Hopkinson pressure bar,
- phase transition point

FullText(HTML)

References(22)

References

[1]	BOYER R R. An overview on the use of titanium in the aerospace industry [J]. Materials Science and Engineering: A, 1996, 213(1/2): 103–114. doi: 10.1016/0921-5093(96)10233-1
[2]	LEE S W, PARK C H, HONG J K, et al. Effect of solution treatment and aging conditions on tensile properties of Ti-Al-Fe-Si alloy [J]. Materials Science and Engineering: A, 2017, 697: 158–166. doi: 10.1016/j.msea.2017.05.022
[3]	母果路, 廖强, 王兴, 等. 固溶加时效处理对Gr.36钛合金棒材组织及性能的影响 [J]. 钛工业进展, 2017, 34(2): 28–32. MU G L, LIAO Q, WANG X, et al. Effect of solution and aging treatment on microstructures and mechanical properties of Gr.36 titanium alloy bars [J]. Titanium Industry Progress, 2017, 34(2): 28–32.
[4]	RAN C, ZHOU Q, CHEN P W, et al. Comparative experimental study of the dynamic properties and adiabatic shear susceptibility of titanium alloys [J]. European Journal of Mechanics-A/Solids, 2021, 85: 104137. doi: 10.1016/j.euromechsol.2020.104137
[5]	RAN C, SHENG Z M, CHEN P W, et al. Effect of microstructure on the mechanical properties of Ti-5Al-5Mo-5V-1Cr-1Fe alloy [J]. Materials Science and Engineering: A, 2020, 773: 138728. doi: 10.1016/j.msea.2019.138728
[6]	RAN C, CHEN P W, LI L, et al. High-strain-rate plastic deformation and fracture behaviour of Ti-5Al-5Mo-5V-1Cr-1Fe titanium alloy at room temperature [J]. Mechanics of Materials, 2018, 116: 3–10. doi: 10.1016/j.mechmat.2017.08.007
[7]	冉春, 陈鹏万, 李玲, 等. 中高应变率条件下TC18钛合金动态力学行为的实验研究 [J]. 兵工学报, 2017, 38(9): 1723–1728. doi: 10.3969/j.issn.1000-1093.2017.09.008 RAN C, CHEN P W, LI L, et al. Experimental research on dynamic mechanical behavior of TC18 titanium alloy under medium and high strain rates [J]. Acta Armamentarii, 2017, 38(9): 1723–1728. doi: 10.3969/j.issn.1000-1093.2017.09.008
[8]	邹学韬, 张晓晴, 姚小虎. 压剪载荷作用下TB6钛合金的动态力学性能 [J]. 高压物理学报, 2019, 33(2): 024206. doi: 10.11858/gywlxb.20190713 ZOU X T, ZHANG X Q, YAO X H. Dynamic behavior of TB6 titanium alloy under shear-compression loading [J]. Chinese Journal of High Pressure Physics, 2019, 33(2): 024206. doi: 10.11858/gywlxb.20190713
[9]	庄仕明, 丰树平, 王春彦, 等. 高应变率下TC4及TC9钛合金的动态断裂 [J]. 高压物理学报, 1995, 9(2): 96–106. doi: 10.11858/gywlxb.1995.02.003 ZHUANG S M, FENG S P, WANG C Y, et al. Dynamic fracture of TC4 and TC9 titanium alloys at high strain rates [J]. Chinese Journal of High Pressure Physics, 1995, 9(2): 96–106. doi: 10.11858/gywlxb.1995.02.003
[10]	NASERI R, CASILLAS G, MITCHELL D R G, et al. Effect of strain on microstructural development during uniaxial compression of metastable beta Ti-10V-2Fe-3Al alloy [J]. Materials Science and Engineering: A, 2021, 804: 140720. doi: 10.1016/j.msea.2020.140720
[11]	QI L C, QIAO X L, HUANG L J, et al. Effect of structural stability on the stress induced martensitic transformation in Ti-10V-2Fe-3Al alloy [J]. Materials Science and Engineering: A, 2019, 756: 381–388. doi: 10.1016/j.msea.2019.04.058
[12]	QUAN G Z, LV W Q, LIANG J T, et al. Evaluation of the hot workability corresponding to complex deformation mechanism evolution for Ti-10V-2Fe-3Al alloy in a wide condition range [J]. Journal of Materials Processing Technology, 2015, 221: 66–79. doi: 10.1016/j.jmatprotec.2015.02.002
[13]	SONG B, CHEN Y, XIAO W L, et al. Formation of intermediate phases and their influences on the microstructure of high strength near-β titanium alloy [J]. Materials Science and Engineering: A, 2020, 793: 139886. doi: 10.1016/j.msea.2020.139886
[14]	MA X K, CHEN Z, XIAO L, et al. Stress-induced martensitic transformation in a β-solution treated Ti-10V-2Fe-3Al alloy during compressive deformation [J]. Materials Science and Engineering: A, 2021, 801: 140404. doi: 10.1016/j.msea.2020.140404
[15]	CHEN W, YAO S S, LIU R L, et al. Enhanced grain refining efficiency assisted by martensitic transformation in metastable β-titanium alloy [J]. Rare Metal Materials and Engineering, 2015, 44(7): 1601–1606. doi: 10.1016/S1875-5372(15)30100-4
[16]	张俊喜, 易湘斌, 沈建成, 等. 固溶和工作温度对TC21钛合金动态压缩性能和绝热剪切敏感性的影响 [J]. 材料导报, 2020, 34(24): 24092–24096. doi: 10.11896/cldb.19070199 ZHANG J X, YI X B, SHEN J C, et al. Influence of solution and ambient temperature on dynamic compression mechanical properties and adiabatic shear sensitivity of TC21 titanium alloy [J]. Materials Reports, 2020, 34(24): 24092–24096. doi: 10.11896/cldb.19070199
[17]	LI C L, ZOU L N, FU Y Y, et al. Effect of heat treatments on microstructure and property of a high strength/toughness Ti-8V-1.5Mo-2Fe-3Al alloy [J]. Materials Science and Engineering: A, 2014, 616: 207–213. doi: 10.1016/j.msea.2014.08.025
[18]	鹿超龙, 杨文成, 权国政, 等. 固溶+时效处理对TB6钛合金组织的影响 [J]. 热加工工艺, 2020: 1–4. doi: 10.14158/j.cnki.1001-3814.20181298 LU C L, YANG W C, QUAN G Z, et al. Effect of solution and aging treatment on microstructure of TB6 titanium alloy [J]. Hot Working Technology, 2020: 1–4. doi: 10.14158/j.cnki.1001-3814.20181298
[19]	易湘斌, 芮执元, 贺瑗, 等. 不同冷却润滑条件下TB6钛合金高速铣削切屑形态研究 [J]. 制造技术与机床, 2019(7): 85–88. doi: 10.19287/j.cnki.1005-2402.2019.07.016 YI X B, RUI Z Y, HE Y, et al. Study on chip morphology of TB6 titanium alloy in high speed milling under different cooling and lubrication conditions [J]. Manufacturing Technology and Machine Tool, 2019(7): 85–88. doi: 10.19287/j.cnki.1005-2402.2019.07.016
[20]	王礼立, 余同希, 李永池. 冲击动力学进展[M]. 合肥: 中国科学技术大学出版社, 1992. WANG L L, YU T X, LI Y C. Progress in impact dynamics [M]. Hefei: University of Science and Technology of China Press, 1992.
[21]	叶萃. TB6钛合金室温塑性机制研究[D]. 贵阳: 贵州大学, 2015. YE C. Study on room temperature plasticity mechanism of TB6 titanium alloy [D]. Guiyang: Guizhou University, 2015.
[22]	BAI Y L, XUE Q, XU Y B, et al. Characteristics and microstructure in the evolution of shear localization in Ti-6A1-4V alloy [J]. Mechanics of Materials, 1994, 17(2/3): 155–164. doi: 10.1016/0167-6636(94)90056-6

Relative Articles

Supplements(0)

Cited By

Proportional views

Proportional views

通讯作者: 陈斌, bchen63@163.com

1.
沈阳化工大学材料科学与工程学院沈阳 110142

Figures(10) / Tables(2)

Get Citation

PDF

XML

Article Metrics

Article views(712) PDF downloads(28)

Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy

doi: 10.11858/gywlxb.20210762

Abstract

References

Proportional views

Catalog

通讯作者: 陈斌, bchen63@163.com

Article Metrics

Proportional views

Related

Effect of Solution Temperature on Dynamic Mechanical Properties and Microstructure of TB6 Titanium Alloy

doi: 10.11858/gywlxb.20210762

Abstract

References

Proportional views

Catalog

通讯作者: 陈斌, bchen63@163.com

Article Metrics

Proportional views

Related

Export File

Citation

Format

Content